[hardware]
baud = 9600
data bits = 8
parity = none
stop bits = 1

[software]
line length = 1408
input timeout = 10
#delimiters = 0xa
# passthrough, passthrough2, telnet, or lpd
protocol = passthrough2

[flow control]
# yes or no (for all but cts)
incoming software = no
rts = no
dtr = no
outgoing software = no
# yes, no, or rts
cts = no
dsr = no

[i/o control]
# passthrough or none
rts = none
# passthrough or none
dtr = none
# negate, assert, sleep, or passthrough
cts = assert
# negate, assert, sleep, or passthrough
dsr = assert
# how often to retransmit passthrough I/O (in seconds; 0 = disable)
resend interval = 0
# socket that governs passthrough I/O (must use RMP)
socket = rmpbind

[passthrough]
socket = rmpbind

[passthrough2]
listen = tcpbind1a
connect = tcpbind1b

[telnet]
# wait for keystroke or command prompt
connect = command prompt
# prompts to use in "wait for keystroke" mode (1 = before, 2 = after)
wait data 1 = "Press any key to connect to host... "
wait data 2 = 0xd 0xa
# fixed IP address to connect to (if in auto or wait modes)
ip address = 10.10.10.129
# fixed TCP port to connect to (if in auto or wait modes)
tcp port = 23
# after disconnect, try again?
reopen after shutdown = on

[rmpbind]
protocol = rmp
# The default address is this unit's serial number
source address = default
source address filter = none
destination address = dynamic
transmit try count = infinite
transmit retry interval = 100

[tcpbind1a]
protocol = tcp
local tcp port = 4000
reopen after shutdown = on
#socket connect data = "Please login: "
#serial connect data = "Received listener connection." 0xd 0xa
#serial disconnect data = "Disconnected from listener." 0xd 0xa
#serial fail data = "Accept failed." 0xd 0xa

[tcpbind1b]
protocol = tcp
ip address = 10.10.10.129
remote tcp port = 4000
reopen after shutdown = on
#socket connect data = "Hello!" 0xd 0xa
#serial connect data = "Connected to socket." 0xd 0xa
#serial disconnect data = "Disconnected from socket." 0xd 0xa
#serial fail data = "Connection failed." 0xd 0xa

[tcpbind2]
protocol = tcp
type = listen
local tcp port = 4000
reopen after shutdown = on
socket connect data = "Please login: "
serial connect data = "Received listener connection." 0xd 0xa
serial disconnect data = "Disconnected from listener." 0xd 0xa
serial fail data = "Accept failed." 0xd 0xa

[tcpbind3]
protocol = tcp
type = connect
ip address = 10.10.10.129
remote tcp port = 4000
reopen after shutdown = on
#socket connect data = "Hello!" 0xd 0xa
#serial connect data = "Connected to socket." 0xd 0xa
#serial disconnect data = "Disconnected from socket." 0xd 0xa
#serial fail data = "Connection failed." 0xd 0xa